![]() ![]() Make: *** Error 4Īrm-rpi-linux-gnueabihf-g++: internal compiler error: Killed (program cc1plus) Then it starts throwing a lot of internal compiler errors. Running step 6 (the cmake build command) after this goes well until 79%. – Build files have been written to: /tflite_build – Could NOT find CLANG_FORMAT: Found unsuitable version “10.0.0”, but required is exact version “9” (found /usr/bin/clang-format) – Performing Test COMPILER_SUPPORT_OPENMP – Performing Test COMPILER_SUPPORT_wd2304 - Failed – Performing Test COMPILER_SUPPORT_wd2304 ![]() – Performing Test COMPILER_SUPPORT_wd981 - Failed – Performing Test COMPILER_SUPPORT_Wcpp11extensions - Failed – Performing Test COMPILER_SUPPORT_Wcpp11extensions – Performing Test COMPILER_SUPPORT_Wenumconversion - Failed ![]() – Performing Test COMPILER_SUPPORT_Wshorten64to32 - Failed – Looking for pthread_create in pthreads - not found – Performing Test CMAKE_HAVE_LIBC_PTHREAD - Failed – Performing Test CMAKE_HAVE_LIBC_PTHREAD – The CXX compiler identification is GNU 6.5.0 – The C compiler identification is GNU 6.5.0 – Setting build type to Release, for debug builds use’-DCMAKE_BUILD_TYPE=Debug’. In the section " Build for Raspberry Pi Zero (ARMv6)" and then the instructions for “download toolchain” a second line should be added that reads “mkdir -p $" -DCMAKE_VERBOSE_MAKEFILE:BOOL=ON -DCMAKE_SYSTEM_NAME=Linux -DCMAKE_SYSTEM_PROCESSOR=armv6 -DTFLITE_ENABLE_XNNPACK=OFF …/tensorflow_src/tensorflow/lite Step 3 also needs to be done but not yet. To be more accurate you need to execute step 1 and 2 shown on that referenced page. Please check Build TensorFlow Lite with CMake page for the details." In the PREREQUISITES section it states " You need CMake installed and downloaded TensorFlow source code. The instructions for Tensorflow Lite cross compilation for ARM are inaccurate (contain errors/omissions, as far as I can see), as follows: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |